Bell System bell free Spezifikationen PDF herunterladen (Seite 15)

BF Apartment Station Digital Entry System

PD–166 Issue 1 Installation and Operating Manual Page 15 of 48

Apartment Station

The apartment station is designed to be surface or flush wall mounted onto plasterboard or

other masonry at an optimum screen height of 1.6m. DDA considerations may reduce this

height to 1.4m. Dimensions are shown in the diagrams below.

Surface Mounting

Flush Mounting

Mounting requires three No 8 screws (not

supplied) and wall plugs may also be

needed for a secure fixing.

Flush fixing requires a hole in the

plasterboard reinforced with batons to give a

solid fixing for the four or six No 8 screws.

The reinforcing batons are longer than the

cut-out, so they may need to be split to allow

insertion.

The apartment station unit is removed from the wall mounting box by pushing in the two

circular buttons at the bottom and pulling apart, once open far enough the two hanging

clips will release/lift off.

Replace the apartment station unit by hanging it on to the two hooks at the top of the wall

mounting box and then push the bottom of the unit onto the two sprung clips.

Top, bottom and rear cable entry alternatives are available in the wall mounting box.

The Video terminator and dip-switch options are available from the back of the removable

unit.

The video terminator jumper is next to the removable 10 way connector block. Dip-switch

settings are summarised on the adjacent label (see also Page 25).

Doorbell

The apartment station has a doorbell function which is activated by the closure of a

normally open contact. This would typically be from a non-illuminated door push.

Reinforcing batons

178mm

Wall Cut-out

118mm

86mm

137mm

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Keine Kommentare

Bell System bell free Spezifikationen Seite 15