Bell System CS106 Bedienungsanleitung PDF herunterladen (Seite 14)

C106 Keypad

Table 4 - Programming of Other Functions

No Function Key Sequence Factory Setting

91 Security key

91 * <1-8 digits> #

1 2 12

95 Lock Duration

95 * <1-99 secs> #

3 seconds

96 Lock Delay

96 * <0-99 secs> #

0 (Disabled)

Program Factory

Settings

99 * #

C106 Keypad

Commissioning

After installation of the C106 unit, follow the two test procedures below; any

problems can be diagnosed from the troubleshooting section. Finally program

the required security and access codes (page 15).

Testing The Lock Release Outputs

Ensure that the lock release is connected to the correct output (as shown in the

Wiring diagram on page 7).

Press and hold the C106 Keypad TEST button:

! Both of the Lock Outputs (Fail-

Safe and Fail-Secure) and both red

and green LEDs will illuminate.

! After 5 seconds the LEDs will start

to alternate and the lock output will

stop operating; you should release

the test button at this stage to

avoid programming the factory

settings (see page 30).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 22 23

Keine Kommentare

Bell System CS106 Bedienungsanleitung Seite 14