Bell System CS106 Bedienungsanleitung PDF herunterladen (Seite 15)

C106 Keypad

Testing the controller with factory settings

Before proceeding with this test ensure that the lock release is working correctly

by following the tests on page 26.

Program to factory settings by following the instructions on page 22, 30.

— Type in code 1 (1 2 3 4 5) - this should operate the lock release for 3

seconds.

— If a time clock is present on the system, manually switch it to OFF and

type code 2 (6 7 8 9 0), nothing should happen. Now manually switch

the time clock to ON and retype code 2 (6 7 8 9 0) - the lock release

should operate for 3 seconds.

— Reprogram code 1 to another value by following the instructions under

the heading ‘Programming new access codes’ (page 15); check that the

new code operates the lock release and that the old one does not.

— If everything is functioning correctly, reprogram the security key (factory

set to 1212), to maintain security.

— Reprogram access codes, action codes and other parameters as required

(pages 14 to 22).

C106 Keypad

Troubleshooting

Use the table below to determine the most probable cause of a fault condition.

Symptom Possible Cause/Remedy

When power applied nothing

happens (LEDs do not flash)

Ž Power Supply is overloaded. Remove

externally connected components until

the fault disappears.

Ž Polarity not correct. Measure the

voltage at the C106 (+ , -)

Ž Check Power Supply Fuses. Always

replace with fuses of the correct type

and rating.

Lock release operates in

reverse

Ž Incorrect output has been used;

Transpose connections between Fail-

safe and Fail-secure outputs.

Red and Green LEDs flash

together when attempting to

operate lock-release.

Ž Fail-secure Lock release output is

short-circuited or of an incorrect rating;

temporarily disconnect the lock release

and retry (Green LED on for 3 secons),

test lock release (page 26)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare

Bell System CS106 Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ziffernblock Bell System CS106