Bell System CS106 Bedienungsanleitung PDF herunterladen (Seite 4)

C106 Keypad

Time-Restricted Access (Staff/Executive Operation)

Any of the ten access codes may be programmed to operate during a restricted

time period only. This time period can be determined by a time-clock or

manually via a key switch.

For example, with factory settings, the operation of code 1 is unrestricted

(Executive Code) whilst code 2 is restricted to when the time-clock input is closed

(Zone 1 - Staff Code).

Codes can also be programmed to operate during alternate shifts. e.g. code 1

operates when the time-clock input is open (Zone 2) and code 2 operates when

the time-clock input is closed (Zone 1).

Refer to ‘Programming the Action Codes’ page 18 and Table 1 page 24 for

further details.

Exit Facility

The Exit facility enables the lock release to be operated directly from a push-

button for the predetermined lock duration. Typically this would be used to allow

personnel to freely exit through the controlled door. The facility may also be

used for a Firemans’ keyswitch, or to interface with other security products such

as a Door Entry Telephone System.

Lock Delay

If required, the lock release can be programmed to operate after a preset time

delay, following entry of the access code. This function is useful if the keypad

is located a significant distance from the entrance.

C106 Keypad

Non-Volatile Memory

The access codes and user programs are stored in a protected non-volatile

EEPROM memory, which does not rely on batteries. The access codes and

other programmable parameters are retained indefinitely without power.

Programmable Options

In addition to the ten access codes the user may program the following other

functions:

— Lock Duration (1-99 seconds)

— Lock Delay Time (0-99 seconds)

— Time-Restricted Access

1 2 3 4 5 6 7 8 9 ... 22 23

Keine Kommentare

Bell System CS106 Bedienungsanleitung Seite 4